Waterpik Technologies Aqua Rite Electronic Chlorine Generator Manuale Utente

888-921-POOLElectronic Chlorine Generatorby LDLINECONTROLS INC.Gwww.goldlinecontrols.comAQUA ITER®

7"Desired Output %" adjustment knobThe "Desired Output %" adjustment knob is located in the lower center of the AquaRite control p

8Maintaining the Aqua Rite SystemTo maintain maximum performance, it is recommended that you open and visuallyinspect the cell every 3 months or after

9INSTALLATIONInstallation must be performed in accordance with Local and NEC codes.Preparing Pool/Spa WaterRefer to page 1 for recommended chemical le

PlumbingEnsure that the Aqua Rite® installation does not constitute a cross connection withthe local potable water supply. Consult local plumbing code

11WiringPower must be shut off at the circuit breaker before performing any wiring. Be sureto follow Local and NEC electrical codes. To provide safe

12Input Power for use with Jandy AquaLink® RS:Wire the AquaRite® DIRECTLY to 120/240VAC power (not through timer or re-lay).Optional Jandy AquaLink RS

13TroubleshootingVisit www.goldlinecontrols.com for helpful information on operation, maintenanceand troubleshooting your Aqua Rite® Electronic Chlori

144. "Low Salt" LED illuminated or flashingCheck salt level in pool/spa. If salt level is low, add salt according to chart on page4. Befo

15Aqua Rite® & Aqua Trol® Limited WarrantyThis warranty statement is applicable to all Aqua Rite and Aqua Trol units with product datecodes of Jan

165. Problems resulting from installing less than one Aqua Rite unit per 40,000 gallons(25,000 gallons commercial/public pools) or one Aqua Trol unit

IMPORTANT SAFETY INSTRUCTIONSWhen using this electrical equipment, basic safety precau-tions should always be followed, including the following:• READ

Questions? Refer to www.goldlinecontrols.com for latest manualrevisions, additional information and helpful service. Or, youmay visit your local Auth

Table of ContentsOPERATIONOPERATIONOPERATIONOPERATIONOPERATIONGeneralGeneralGeneralGeneralGeneral...

1OPERATIONThe Aqua Rite® is an automatic chlorine generation system for pool or spa sanita-tion. The operation requires a low concentration of salt (

Saturation indexThe saturation index (Si) relates to the calcium and alkalinity in the water and is anindicator of the pool water "balance".

3Salt LevelUse the chart on page 4 to determine how much salt in pounds or (Kgs) need to beadded to reach the recommended levels. Use the equations b

4Gallons and (Liters) of Pool/Spa water12,000 14,000 16,000 18,000 20,000 22,000 32,00024,000 34,00026,000 36,00028,000 38,00030,000 40,000Current sal

5POUNDS and (Kg) OF STABILIZER (CYANURIC ACID) NEEDED FOR 80 PPMGallons and (Liters) of Pool/Spa waterCurrentStabilizerLevel (ppm) 0 ppm20 ppm60 ppm30

6ControlsMain SwitchNote: When the Aqua Rite® is being controlled by the optional Jandy AquaLink®RS, the main switch will not funciton.AUTO: For nor